Temperature Data Processing
ODP Logging Contractor: LDEO-BRG
Hole: 965A
Leg: 160
Location: Eratosthenes Sea Mount (Eastern Mediterranean)
Latitude: 33° 55.080' N
Longitude: 32° 42.786' E
Logging Date: March, 1995
Bottom Felt: 1517.7 mbrf (used for depth shift to sea floor)
Total Penetration: 250.4 mbsf
Total Core Recovered: 42.8 m (%)
Water Depth: 1517.7 mbrf
Temperature Tool Used: LDEO-TLT
Depth versus time recording available: NO
Logging Runs
Logging string 1: DIT/SDT/NGT
Logging string 2: HLDT/CNTG/NGT
Wireline heave compensator was used to counter ship heave.
The LDEO-TLT tool is a self-contained, high precision, low-temperature logging tool that is attached to the bottom of the Schlumberger tool strings. The tool provides two temperature measurements (in degree Celsius, recorded by a fast-response and a slow-response thermistor. The fast-response thermistor, though low in accuracy, is able to detect sudden, small temperature excursions caused by fluid flow between the formation and the borehole. The highly accurate, slow-response thermistor can be used to estimate heat flow. Pressure and the two temperature measurements are recorded as a function of time: conversion to depth can be based on the pressure reading (Legs 123-157) or, preferably, on simultaneous recording (by Schlumberger) of depth and time (Legs 159-181). During Leg 160 depth versus time data were collected at Holes 966F, 968A, and 970A only.
A linear relationship of pressure versus depth has been calculated from the pressure reading at the mudline. The pressure at the mudline corresponds to the pressure recorded by the tool during the calibration stop (about 5 minutes), which takes place at the mudline on each logging run.
Depth = Pressure * x - WD
where
Depth = mbsf
Pressure = bars
x = pressure conversion coefficient (m/bars)
WD = water depth, mbrf
This procedure does not fully account for the vagaries of the pressure readings that result in lots of ups and downs in the generated depth channel. Further problems arise because of pumping during logging operations, which affects the pressure, especially when the Side Entry Sub is used. Also, whenever heavy pills of mud are used, the pressure-depth calculation is affected, resulting in a non-linear effect that is difficult to account for. If the pressure conversion coefficient is recalculated for the mudline, the resultant total depth is often wrong.
The following processing has been performed at Hole 965A:
Logging Run: DIT/SDT/NGT
Mudline P=145.3 bars
x=WD/145.3=10.44
Pressure conversion factor calculated from pressure at mudline
Depth = Pressure * 10.44-1517.7
Logging Run: HLDT/CNTG/NGT
Mudline P=156 bars
x=WD/156=9.7252
Pressure conversion factor calculated from pressure at mudline
Depth = Pressure * 9.7252-1517.7
Information about the temperature logging operations can be found in the Site Chapter (Operations, Downhole Measurements, and Heat Flow sections), ODP IR volume 160.
For any question about the data or about the LogDB database, please contact LogDB support: logdb@ldeo.columbia.edu.