Temperature Data Processing

 

ODP logging contractor: LDEO-BRG

Hole: 1072B

Leg: 174A

Location: New Jersey Rise (NW Atlantic)

Latitude: 39° 21.9305' N

Longitude: 72° 41.6647' W

Logging date: July, 1997

Bottom felt: 109.5 mbrf

Total penetration: 358.6 mbsf

Total core recovered: none

 

Water Depth: 109 mbrf

Temperature Tool Used: LDEO-TLT

Depth versus time recording available: YES

 

Logging Runs

 

Logging string 1: DIT/LSS/NGT

Wireline heave compensator was used to counter ship heave.

 

Tool Information

 

The LDEO-TLT tool is a self-contained, high precision, low-temperature logging tool that is attached to the bottom of the Schlumberger tool strings. The tool provides two temperature measurements (in degree Celsius, recorded by a fast-response and a slow-response thermistor.  The fast-response thermistor, though low in accuracy, is able to detect sudden, small temperature excursions caused by fluid flow between the formation and the borehole. The highly accurate, slow-response thermistor can be used to estimate heat flow. Pressure and the two temperature measurements are recorded as a function of time: conversion to depth can be based on the pressure reading (Legs 123-157) or, preferably, on simultaneous recording (by Schlumberger) of depth and time (Legs 159-181).

 

Data Processing

 

During this leg depth versus time data was recorded on a personal computer (part of the L-DEO digital logging data acquisition system in the ODP Downhole Measurements Laboratory aboard the JOIDES Resolution) with input from the Schlumberger MAXIS computer. The depths recorded through this system are the same used by Schlumberger to measure cable length as recorded in the logging data files. These depth data were merged with the data recorded in memory by the Temperature Logging Tool (TLT) by matching absolute time in the two data sets. Time versus depth data from the MAXIS was available during logging at all holes. The depths in the processed files are reported in meters below sea floor (mbsf). At each hole, the constant depth shift applied to the original temperature logs was the same as that applied to all of the other logs; it is given in meters below rig floor (mbrf) in the header of the processed files.

 

Information about the temperature logging operations can be found in the Site Chapter (Operations, Downhole Measurements, and Heat Flow sections), ODP IR volume 174A.

 

For further information about the processing, please contact:

 

Cristina Broglia
Phone: 845-365-8343
Fax: 845-365-3182
E-mail: Cristina Broglia